Multiflex EEC-014 EDGE Engine Control Cable - BRP / Evinrude / OMC - 18ftEngine Control Cables EEC-014-XX (XX is length of cable in feet) are used for Shift and Throttle application. Different designs of Engine Control Cables are used depending on the engine type and installation.
Multiflex offers a wide variety of Engine Control Cables for different applications. Engineered out of corrosion resistant materials and components these control cables meet or exceed all industry standards.
Multiflex Engine Control Cables are interchangeable with most common SeaStar Solutions®, Morse®, Ultraflex® Engine Control Cables.
Applicable for BRP® – Evinrude® (OMC®) Engines manufactured post 1979.
Travel : 80 mm | EDGE Conduit: 8.6 mm | Inner: 2.7 mm (Coated Inner) Flexible core
Features: Special Edge Conduit
Unique design of Conduit provides structural integrity and a tighter minimum bend radius.
Improved Efficiency
Edge cables provide significantly greater efficiency due to use of low-friction materials and construction.
Minimal Backlash
Edge cables are built allowing optimum gap between inner core and conduit, resulting in significantly minimal backlash.
Less Friction Wiper Seal
The wiper seals are made from a polyurethane impregnated with lifetime lubricant to minimize operating friction.
Cable Bend Radius
Edge Cable has a minimum bend radius of 4 inches. However in use keep the bend radius as large as possible and the degree of bend to a minimum for optimal performance.
The above features translates into improved efficiency with reduced operator effort when EDGE cables are used. | 
