Flexible Solar Panel 20W 12v Size: 475 x 345 x 4mm From the 10wp to the 80wp, PV Logic Flexi is well suited for use where a super robust, low profile and lightweight panel is needed, or the substrate to which the panel will be fixed has a slight curve. Ideal for marine buoys, boat decks, camper vans etc. Contents - 1 x STPVF020 – 20wp solar panel
- 1 x 4m Cable (attached)
- 1 x Fuse
- 6 x Ring Terminals
- 1 x Instruction Sheet
Specifications
Power (Wp) 20watts
Nominal Voltage (Vmp) 18V DC
Nominal Current (Imp) 1.11A
Open Circuit Voltage (Voc) 21.6V
Short Circuit Current (Isc) 1.21A
Operating Temperature -40 to + 80 Deg C
Max System Voltage 750V DC
Dimensions 505x345x3mm (Junction box 10mm)
Weight 0.70Kg
Approx. watt-hours/day** 120W
Approx. amp-hours/day** 6.66A
** Based on 6 hours of average daily peak sunlight hours
Self-healing top surface The ETFE top layer gives the PV Logic Flexi extra resilience in really tough conditions. ETFE has a memory effect or self-healing capacity in the event the panel comes into contact with branches etc, thus ensuring any slight abrasions are ‘healed’ within a few hours. The Flexi range can even be walked on with soft deck shoes! During production the ETFE is dimpled to further protect the panel and provide an anti-slip surface, particularly useful if the panel is fitted to a boat deck. Completely waterproof Each panel is assembled to ensure complete encapsulation. This ensures the 6 layer heavy duty laminate protects the solar cell circuit from extreme conditions. The junction box is also injected with special silicon, guaranteeing no water ingress. Cells protected from hot spots. Where used on a camper van or boat, partial shading of a solar panel is typical. In these circumstances, heat build-up and damaging hot spots can occur leading to a significantly reduced life cycle of the panel. The larger 60w and 80w PV Logic Flexi panels have up to two shading diodes housed within the fully waterproof junction box to prevent this occurrence. Superior design There are no square edges on a PV Logic Flexi! Rounded panel corners and a unique curved junction box provide superior adhesion, no snag lamination and no sharp edges. The junction box is mechanically fixed in addition to being bonded to the panel. Strain relief is provided for the fitted 4m UV stabilised PV cable ensuring it cannot be accidentally pulled from the junction box. Easy fix The Flexi range can be bonded to flat or slight curved surfaces (3cm curve per metre) such as painted aluminium, metal, GRP and fibreglass using Simson ISR 70-03. Warranty The Flexi range is setting new standards with a 5 year product and a 20 year performance warranty* . Please note.
All of our semi flexible panels will only bend from the top (has the cable and logos) to the bottom a maximum of 10% of panel length.
Bending the panel greater than this or trying to bend the panel from left to right will possibly damage the panel and also invalidate your warranty. | 
